TailScale

From Da Nerd Mage Wiki
Jump to navigation Jump to search
Proven on:
Logo Debian.png
11 (bullseye)


WIP!!! As always...

Start with:

  • sudo apt update
  • sudo apt upgrade

TailScale HowTo

TailScale & pfSense

Inbound NAT

For some reason, nobody talks about how to use TailScale to actually access your pfSense managed network from the OUTSIDE.

What I've figured out so far...

Assign the TailScale interface:

Interfaces / Assignments & click "Add" beside "tailscale0 (tailscale0)".

Then, in your NAT settings, Firewall / NAT / Port Forward, When you create a NAT forward that uses TailScale, select the Tailscale interface & Any as the destination. This will allow you to treat the TailScale IP address just like you would normally treat the WAN address.

In theory, this page is relevant...

Research required.

There IS some possibility that "exit node", as used by tailscale, does NOT mean what it seems...  hhhmmm...

HeadScale

Now Do A Backup!